Tips & Hints
-
To change the main power fuse, unscrew the 10 top screws in order to remove the top panel.
The main fuse is located on the power supply unit PCB, as shown on the photo.
Turn the cap 90° to the left to open the fuse holder.
Replace the fuse with a new...
-
To change the main power fuse, first remove the batteries out of their compartment and unplug any external power supply.
Unscrew the 6 top screws of the top panel and slide it toward the rear.
The main fuse is located at the right rear, near the blac...
-
The SX-S Sonosax has two fuses: one for the external power inside the mixer, the other for batteries supply, inside the compartment itself.
To change the battery power fuse, first remove the batteries compartment out of its place and remove all batte...
-
The SX-S Sonosax has two fuses: one for the external power inside the mixer, the other for batteries supply, inside the compartment itself.
To change the main power fuse, first remove the batteries compartment out of its place and unplug any external...
-
Do not remove the cap, which is provided with an absorber in order to optimize the aforementioned acoustic impedance: same remarks as above; moreover, the vents protecting grid, while being rotated, gets twisted and must then be changed.
-
Take care to keep clean the tight grille which protects the lateral events; because in case of dust or dirt accumulation, the acoustic impedance presented at the sound wave by the tube is modified by it and consequently the microphone directivity and...
-
The needle ensuring the electronic connection between the capsule and the preamp tends, as time goes on, to unscrew by itself. It also tends to superficially oxidize, and requires from time to time a cleaning with an alcohol solution.
-
Do not remove the cap, which is provided with an absorber in order to optimize the aforementioned acoustic impedance: same remarks as above.
-
Take care to keep clean the tight grille which protects the lateral events; because in case of dust or dirt accumulation, the acoustic impedance presented at the sound wave by the tube is modified by it and consequently the microphone directivity and...
-
The previous internal nylon joints of the VdB boompoles tended to inflate with water. Before any storage, thus think of well cleaning your pole after deployment under the rain or in very wet condition.
-
Be careful that too much tightening the locking collars would decrease their efficiency.
-
The previous internal nylon joints of the VdB boompoles tended to inflate with water. Before any storage, thus think of well cleaning your pole after deployment under the rain or in very wet condition.
